Modulation Plugin
Contents
ToDo
- Voltage during "Lo" time of DAC can also be set (i.e. not necessary zero)
- modulation cct & PCb
- Bias resistors for op-amp
- crystal & SMD res. too close, easy to short when soldering
- footprint of some chips are too small, enlarge it for easily soldering
- some cct modification
- modify the res. value
Objectives
- The modulation module is used to deliver a digital output signal with the following characteristics:
- Square wave
- Variable frequency (0 - >10kHz)
- Variable amplitude (0V - 2.5V)
- Accuracy frequency response (error < 2%)
- interface to MCU which do the control
Software Solution
- Timer Interrupt controlling I2C DAC can only achieve frequency response of about 500Hz
- 5byte/cmd
- 8bit/byte
- baudrate = 400kHz
- This yields 10kHz (0.1ms)
- As OS context switch is 10ms, set timer to 1ms (1kHz), so that 0.9ms can be used to process other tasks
- timer frequency of 1kHz yields a modulation frequency of 500Hz
- Due to higher freq. response requirement, so using hardware to implement the clock
Hardware Solution
Overall Performance
- I2C Baudrate: 400kHz
- Output Voltage Range: 0 - 3.3V
- Output Frequency Range: 0 - 200kHz
- Cannot reach higher frequency due to minimum time to execute code in interrupt routine is about 500ns
- Number of channels: 4
- Accuracy of frequency: <2%
- Conditions: external crystal, no OS context switch, single channel operation
- Measurements (by scope)
- +/-2.100kHz@200kHz => 1.05%
- +/-0.520kHz@100kHz => 0.52%
- +/-0.140kHz@50kHz => 0.28%
- +/-0.006kHz@10kHz => 0.06%
- +/-0.002kHz@5kHz => 0.04%
- +/-0.200Hz@1000Hz => 0.02%
- +/-0.000Hz@500Hz => 0.00%
- +/-0.000Hz@100Hz => 0.00%
- +/-0.0001Hz@50Hz => 0.02%
- +/-0.000Hz@10Hz => 0.00%
- +/-0.000Hz@5Hz => 0.00%
- Accuracy of frequency: <2%
- Conditions: external crystal, no OS context switch, 4 channel operation, Ch2 = 1kHz, Ch3 = 50kHz, Ch4 = 200kHz
- Measurements of ch1 (by scope)
- +/-2.000kHz@200kHz => 1.00%
- +/-0.520kHz@100kHz => 0.52%
- +/-0.130kHz@50kHz => 0.26%
- +/-0.130kHz@10kHz => 0.06%
- +/-0.002kHz@5kHz => 0.04%
- +/-0.200Hz@1000Hz => 0.02%
- +/-0.100Hz@500Hz => 0.02%
- +/-0.000Hz@100Hz => 0.00%
- +/-0.010Hz@50Hz => 0.01%
- +/-0.000Hz@10Hz => 0.00%
- +/-0.001Hz@5Hz => 0.02%
Selected Chips
Part No. | Description |
---|---|
DAC7574IDGS | Quad-channel 12-bit I2C DAC |
dsPIC33FJ256GP506-I/PT | uP programed as I2C Quad-channel programmable clock[*] |
SN74AHC4066PWR | Quad-channel Bilateral Analog Switch |
OPA4340EA | Single-Supply, Quad-channel, Rail-to-Rail Operational Amplifiers |
- [*]Alternatives: DS1089L: 3.3V Center Spread-Spectrum EconOscillator
Circuit
+-----+ +--------+ +--------+ I2C Bus | | | Analog | | Op-Amp | ------------+-----| DAC |------------| Switch |---------| |---------Output | | | +--------+ +--------+ | +-----+ | | | | +--------------+ | | | Programmable | | +-----| Clock |-------+ +--------------+
- This architecture allows the square wave to run at a very high frequency, even with a slow I2C and a slow DAC.
Circuit Simulation by Paul Falstad's Web
- Import the following
$ 1 5.0E-6 16.817414165184545 64 5.0 50 w 128 256 144 256 0 w 16 256 64 256 0 g 16 352 16 368 0 v 64 64 112 64 0 0 40.0 2.5 0.0 0.0 0.5 w 112 128 144 128 0 w 64 128 16 128 0 w 16 128 16 256 0 v 64 256 128 256 0 2 1000.0 1.65 1.65 0.0 0.5 a 336 144 464 144 1 3.3 0.0 w 336 160 336 192 0 w 464 192 464 144 0 w 464 144 512 144 0 r 592 144 592 256 0 1000.0 g 592 352 592 368 0 w 512 144 592 144 0 w 336 192 352 192 0 w 432 192 464 192 0 v 64 128 112 128 0 1 1.0 1.25 1.25 0.0 0.5 w 16 256 16 288 0 w 16 288 16 352 0 w 592 256 592 352 0 g 272 352 272 368 0 w 272 128 336 128 0 w 176 256 176 144 0 r 272 224 272 288 0 10000.0 w 272 128 272 224 0 w 272 288 272 352 0 159 144 128 208 128 0 r 208 128 256 128 0 10000.0 w 256 128 272 128 0 w 144 256 176 256 0 r 336 224 336 288 0 10000.0 g 336 352 336 368 0 w 336 288 336 352 0 w 336 192 336 224 0 r 352 192 432 192 0 10000.0 o 4 64 0 34 2.5 9.765625E-5 0 -1 o 0 64 0 35 5.0 9.765625E-5 1 -1 o 11 64 0 34 2.5 3.90625E-4 2 -1
SVN Server
- Repository: svn+ssh://chungyan5.no-ip.org/home/open_data/electronic_computer/modulation_plugin/svn_rep
- Contains circuit PCB and software for dsPic Programmable Clock
- Also available on ViewVC