Difference between revisions of "Arduino Socket"
Russ hensel (talk | contribs) |
Russ hensel (talk | contribs) |
||
| Line 23: | Line 23: | ||
| − | [[Image: | + | [[Image:Tack.JPG|400px]] |
| − | [[Image: | + | [[Image:Solder.JPG|400px]] |
| + | |||
| + | |||
| + | [[Image:Solder dun.JPG|400px]] | ||
| + | |||
| + | |||
| + | [[Image:Mont it.JPG|400px]] | ||
| + | |||
| + | <!--------------start hidden ------------------ | ||
| + | |||
| + | [[Image:x.JPG|400px]] | ||
| + | |||
| + | [[Image:x.JPG|400px]] | ||
| + | |||
| + | [[Image:x.JPG|400px]] | ||
| + | |||
| + | <!-------------- end hidden ---------------------> | ||
Revision as of 09:08, 2 February 2018
Introduction
There is an old tradition in electronics, if a part is expensive or inclined to blow, make it replaceable by putting it in a socket. Sometimes this goes too far as with final circuits that are still on a proto board where everything is in a socket. But if we are using small arduinos like the nano we more or less treat them as a component and putting them in a socket is a good idea. As far as I know sockets for these parts are not made, and the pins on an arduino are not really the normal pins for sockets. However we can make what we need on a strip board or PCB by using 2 rows of female headers. Pictures tell the rest of the story.
Note that this is an article started by Russ Hensel, see "http://www.opencircuits.com/index.php?title=Russ_hensel#About My Articles" About My Articles
Parts
