Multi-rotor

A multi-rotor helicopter is a flying vehicle with more than one rotor.

The nice people at http://www.quadheli.com/ have asked for our help designing and building a multi-rotor helicopter.

Several people are using small unmanned helicopters with 4 rotors ("quadheli" or "quadcopter").

BLDC

It appears that most modern small electric aircraft use so-called "brushless DC motors", each one driven by its own "BLDC ESC". (These are easily recognized -- BLDC motors have exactly 3 equally-fat wires that go into them, which come from the BLDC ESC -- as opposed to most electric aircraft a few years ago, which used brushed DC motors with exactly 2 equally-fat wires).

While it is probably not cost-effective to build your own BLDC motor or BLDC ESC, many of us are insatiably curious about what goes on inside these things, and so build one anyway:

• Wikipedia: brushless DC electric motor
• Atmel AVR444: Sensorless control of 3-phase brushless DC motors using ATmega48 (also works without change for ATmega88 and ATmega168). Assumes you've already read Atmel AVR443: Sensor-based control of three phase Brushless DC motor
• AVR194: Brushless DC Motor Control using ATmega32M1: BLDC motor control application using Hall effect position sensors to control commutation sequence.
• MikroKopter: brushless motor controller was designed to give lower latency than off-the-shelf PWM ESCs.
• OpenServo: Brushless DC Servo "The thing that will make our board different from other ESC's is that we are closing the feedback loop with a ... outside position reference."

unsorted

way too many links here. Please delete the ones not relevant to multi-rotor helicopters.

• Wikipedia: quadrotor is a nice introduction. But what are these "three rotor craft" it mentions? (TriCopter? Tri-copter?)
• the OpenPilot Wiki [1]: open source community
• The Gluonpilot wiki (autopilot) mentions "Quadrocopter" [2]
• MikroKopter wiki [3] semi-open-source "for noncommercial use"
• QC-Copter Wiki [4] : updates all motor speeds at 500 Hz.
• the NG Multikopter Project wiki [5]: a open source community project to build a modern autonomously flying Multicopter.
• the Wolferl Open Source QuadCopter (Universal Aerial Video Platform) wiki [6]. Apparently NS Rana at DIY Drones uses it in a very low-cost-frame quadcopter[7].
• QuadroCopter Wikia [8]
• ARM-o-Kopter wiki [9]
• comparing some currently known projects of airborne non-commercial or open community projects of multicopters[10]
• DIYdrones: "There are a zillion quad- and tri-copters out there" [11]
• DIYdrones: Quadcopters discussion forum [12]
• DIYdrones: Return to Home Quadrocopter (UAVX) [13]
• DIYdrones: "There are loads of open source quadcopters out there, but they're all ..." [14] Is it possible to design a helicopter that avoids this problem?
• the "ChRoMicro - Cheap Robotic Microhelicopter HOWTO" [15], [16] describes "how to build a 300 g helicopter with embedded Linux and Bluetooth datalink from off-the shelf components for less than 500 EUR." Can these ideas be adapted to helicopters with more rotors?
• Quadrotto: Project Quadcopter [17], [18]. Is there any way to avoid making the same mistakes all over again, and instead make fresh new mistakes? :-).
• RCgroups: Multi Rotor Helis discussion forum [19]
• AeroQuad discussion forum [20]: dedicated to the design and construction of the AeroQuad, a remote controlled four rotor helicopter ... that uses the Arduino (Mega or Duemilanove with 328P) microcontroller as the flight control board, with a "AeroQuad Shield" that connects to all the other electronics -- radio receiver, gyros, accelerometers, and off-the-shelf ESCs. An excellent tutorial showing how it all goes together with whatever frame you have; it claims "A good motor-to-motor distance to start with is around 60cm." (2 foot)
• microdrones [21]
• whatnick blog: "quadcopter taking shape"; and other quadcopter posts ... he apparently has a Gumstix Verdex and a BeagleBoard -- are either one of these going on the quadcopter?
• WSN wiki: wireless sensor node platforms -- perhaps we could use one of these boards for our wireless communication, or perhaps make incremental improvements, rather than designing yet another one from scratch?
• Dr. Igor Bensen designed the eight rotor helicopter on the front page of Popular Mechanics 1982 September.
• "Real-time+stabilization+of+an+eight-rotor+UAV+using+optical+flow" Google: "Real-time stabilization of an eight-rotor UAV using optical flow"
• kapteinkuk built a low-cost quadrotor flight stabilizer based on a Atmel AVR ATMega48 [22]; connected to a standard RC receiver, 3 gyros with ordinary analog output, and 4 ESCs. That's all the electronics.
• ArduPilot [23] is a full-featured autopilot based on the Arduino open-source hardware platform. It uses infrared (thermopile) sensors or an IMU for stabilization and GPS for navigation. Optionally uses XBee modules for wireless telemetry. Jose Julio at DIY Drones [24] uses it in his two quadcopters. He uses 4 standard props (No counter-rotating !).

---