Difference between revisions of "Part Design Parts"

From OpenCircuits
Jump to navigation Jump to search
Line 11: Line 11:
 
Now Part Design parts should be used inside a body and it seems that Part workbench parts cannot be moved into a body.  ( example file would be nice )  In some ways a cylinder is not a  
 
Now Part Design parts should be used inside a body and it seems that Part workbench parts cannot be moved into a body.  ( example file would be nice )  In some ways a cylinder is not a  
 
cylinder.  If you need a cylinder for the Part Design look under Part Design -> Part Design -> Create Additive Primitive -> Additive Cylinder
 
cylinder.  If you need a cylinder for the Part Design look under Part Design -> Part Design -> Create Additive Primitive -> Additive Cylinder
 +
 +
 +
Russ it seems that Part Parts can be used in a part design body in two ways:
 +
Drag and drop them in this creates a xxx which then can be used ??
 +
A sketch attached to a Part not in the body produces a pad that is in the body
 +
 +
[[Category:FreeCad]]
 +
  
  
 
[[Category:FreeCad]]
 
[[Category:FreeCad]]

Revision as of 14:28, 27 May 2018

Introduction

This page is part of a planned series on FreeCad .17. Click on the category FreeCad for some more information.

Part Design

If you used the old part design workbench ( .16 and earlier ) you may have some re-adjustment to the now one. I more or less considered Part Design and Part workbenches to be pretty much sections of a larger workbench. In particular parts from the Part workbench were freely and commonly used in the Part Design workbench. This no longer seems to be the case. Now Part Design parts should be used inside a body and it seems that Part workbench parts cannot be moved into a body. ( example file would be nice ) In some ways a cylinder is not a cylinder. If you need a cylinder for the Part Design look under Part Design -> Part Design -> Create Additive Primitive -> Additive Cylinder


Russ it seems that Part Parts can be used in a part design body in two ways: Drag and drop them in this creates a xxx which then can be used ?? A sketch attached to a Part not in the body produces a pad that is in the body