Difference between revisions of "Part Design Pad and Pocket"
Jump to navigation
Jump to search
Russ hensel (talk | contribs) |
Russ hensel (talk | contribs) |
||
| Line 7: | Line 7: | ||
| − | + | == Questions == | |
| + | |||
| + | |||
| + | == Part Design Primitives == | ||
| + | |||
| + | * How does order matter | ||
| + | * Use booleans on them | ||
| + | * Adding a Part Workbench part. | ||
| + | * Using with pad and pocket | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
[[Category:FreeCad]] | [[Category:FreeCad]] | ||
Revision as of 12:06, 27 May 2018
Introduction
FreeCad has a new version .17. I am in a bit of a struggle with it and thought rather than just complain I would write a bit about it and try to help other overcome any problems with it. So here goes:
This is an article started by Russ Hensel, see "http://www.opencircuits.com/index.php?title=Russ_hensel#About My Articles" About My Articles for a bit of info. The page is only partly finished, it may or may not ever be finished.
Questions
Part Design Primitives
- How does order matter
- Use booleans on them
- Adding a Part Workbench part.
- Using with pad and pocket
