Editing Linuxstamp II 8-channel RC Control board

[[Image:Servo_ls2_small.JPG]]
[[Image:Linux_boebot_chasis.JPG]]

== Description ==
This board can control up to 8 RC servos via the onboard Pololu chip. A simple serial line from the Linuxstamp II controls the Pololu chip. There is also a prototyping area with access to power as well as UART, SPI, I2C & GPIO lines from the Linuxstamp II.

== Power supply ==
There are two options for the poser supply. Most of the time a 1.5A linear regulator from ST should be fine (digikey p/n 497-3468-1-ND). However if more current is needed a switching power supply from Recom can be used (digikey p/n 945-1028-ND).

== License ==
All files for this project are licensed under the GNU GPL V2

== Hardware design files ==
Warning!!! Use this design at your own risk.
You can find the design files [http://linuxstamp.budgetdedicated.com/index.php?dir=motherboards/servo/ here].

== Demo programs ==
There are 2 demo programs that can be found [http://code.google.com/p/ls2sw/source/browse/#svn%2Ftrunk%2Fservo here.]

== Mounting ==
The mounting holes on the board are designed to match the [http://www.parallax.com/Store/Robots/AllRobots/tabid/755/CategoryID/2/List/0/SortField/0/Level/a/ProductID/267/Default.aspx boebot] Chassis. So the board can be used with continuous rotation servos to make a little rover.